Pellet Stove Fan Control

Pellet stoves can’t really, in my opinion, be controlled by a thermostat. They take a long time to start, and up to 30 minutes sometimes to shut off. And in my situation, I need a fan to blow the warm air into other rooms of the house. So, there is a pedestal fan next to the stove to blow the warm air to the rest of the house. But I had to manually start and stop that fan.

The problem is that if the fan is started with the stove, it blows cold air for a long time before the stove warms up. And when I shut off the stove, I have to come back later and turn off the fan, maybe at night when I just want to go back to sleep.

So here’s the solution. There are “Temperature Controllers”. I found several on Amazon. This one looks very fancy, but was only about $35. It can control heating and cooling of something and has a large wattage rating. So the fan is plugged into the Cooling socket and the temperature is set to 85 degrees. So the fan is always off unless the stove is hotter than 85 degrees. So when the stove is turned on, the fan comes on about 5-7 minutes later when the stove has warmed up, and when the stove is shut off, the fan shuts off up to 30 minutes later when the stove has cooled down.

Notice the thin wire sneaking over to the top left of the stove? That’s the thermo sensor that controls the controller.

Works great. Now I don’t need to worry about the fan at all. Just turn the stove on and off when I need it.

:ww